Kia Soul: Steering wheel / Heated steering wheel

Kia Soul (SK3) 2020-2025 Owners Manual / Features of your vehicle / Steering wheel / Heated steering wheel

Kia Soul. Heated steering wheel

With the ignition switch in the ON position, pressing the heated steering wheel button warms the steering wheel. The indicator on the button will illuminate.

To turn the heated steering wheel off, press the button once again. The indicator on the button will turn off.

NOTICE

The heated steering wheel will turn off automatically approximately 30 minutes after the heated steering wheel is turned on.

If you turn off the ignition within 30 minutes after pressing the steering wheel heater button, from next ignition ON, the heater will be off.

CAUTION

Do not install any grip to operate the steering wheel. This causes damage to the heated steering wheel system.

Tilt & telescopic steering

A tilt and telescopic steering wheel allows you to adjust the steering wheel before you drive. You can also raise it to give your legs more room when you exit and enter the vehicle. The steering wheel ...

Horn

To sound the horn, press the area indicated by the horn symbol on your steering wheel (see illustration). The horn will operate only when this area is pressed. Check the horn regularly to be sure it operates ...

Other information:

Kia Soul (SK3) 2020-2025 Owners Manual: Wheel replacement. Tire traction and maintenance

Wheel replacement When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct size may adversely affect wheel and bearing life, braking and stopping abilities, handling ...

Kia Soul (SK3) 2020-2025 Owners Manual: Side repeater lamp (Bulb type) bulb replacement

1. Remove the lamp assembly from the vehicle by prying the lens and pulling the assembly out. 2. Disconnect the bulb electrical connector. 3. Separate the socket and the lens parts by turning the socket counterclockwise until the tabs on the socket align with the slots on the lens part. 4. Remove the ...